Shiruba XB-2100 Hang on Filter with Bio ceramic Media

Shiruba XB-2100 Hang on Filter with Bio ceramic Media

• For use in 80 L or less aquariums
• Max water flow 560 L/Hr
• Efficient fitration design
• Special design leading water to go through cartridge nearly completely
• Adjustable water flow switch
• No need to add water after restart
• High quality ABS with high durability
• Design and made in Taiwan

Caution :-

• Read full instructions carefully. Before assembly and look for Warning Signs marked on the product.
• Use correct power supply voltage for this product. Electrical rating lable is located at the bottom of the filter. Use a secured stand-alone power outlet for the filter.
• Make sure to install the filter correctly before operating. The filter chamber must filled up with water before the filter is plugged into the power outlet. Otherwise, the pump may burned out.
• If the power outlet is located below the filter, drop the power cord lossely creating a drip loop to prevent water from dripping into the power outlet (as shown in picture on box).
• This filter is for indoor use only. Operate the filter with temperature at 50°F-95°F (10°C-35°C). The pump’s maximum lifting height is 110cm.
• Unplug the power cord when the filter is not in use. Before installation, or when filter is being cleaned.
• When setting up a new aquarium, run the filter 24 hours before stocking with fish.
• The power supply cord cannot be replaced. If the cord is damaged, the filter should be discarded.
• This filter is not intended for use by children or persons with reduced physcial or mental capabilities, or lack of experience and knowledge.